Chimney Hardware & Earthing Rods
Chimney bracket light duty is of welded angle iron & flat bar construction with 4.5" between mast fixing centres and will handle a 1.5" aluminium mast.
Overall height of bracket is 6" with a 2" clearance from chimney.
Bracket is of welded angle iron construction with 7.5" between mast fixing centres and will handle a 2" aluminium mast.
Overall height of bracket is 9" with a 3" clearance from chimney.
This chimney bracket is of cradle type construction and requires a single lashing and will handle up to a 2” (50mm) aluminium mast.
Overall height of 13.5" and chimney to mast clearance 4”.
Machined brass cable clamp with M8 brass clamp screw and double nut and washer.
This chimney bracket 5" Clearance and sold in pairs will give adequate support proportional to spacing and suitable for 1.5” - 2” (50mm) aluminium mast.
Designed and Manufactured by BARENCO
4ft Copper coated steel Earthing Rod.
Complete with machined brass connector, M8.
Seven strand 18 gauge wire in 17ft coils suitable for chimney bracket lashing.
Suitable for areas were an overhang or ornate structure needs to be cleared. Sold in pairs.
Finish : Hot Dipped Galvanized
Standard 'J' bolt for securing chimney bracket tensioning.
Overall Length : 125mm
Thread Length 90mm x 3/8" Whit Thread and Nut.
Large corner plate for lashing wire protection around chimney corners.
Note. Only 3 required for each lashing wire.
Finish : Plated